Quote:
Originally Posted by amanbra
Okay my 126200 which I have had many issues first purchased sept 2019. Same process wait 24 hours measure then full wind and wait 15 mins and measure. Note this watch hits 280s immediately after full wind.
|
If I understand you correctly, you do the following:
(1) Full winding #1, then no measurement.
(2) Wait 24 hours, then measure 5 positions.
(3) Full winding #2, wait 15 min, then measure 5 positions
Why do you use this sequence? It needs two full caliber windings.
Is your watch all time (24 hours) at rest after the first winding?
How long is your stabilisation time after each position change?
How long is your measurement time in each position?
Would be good to add X and D to your table.