Quote:
Originally Posted by Rich Mickol
Not the outcome I was hoping for but probably the right one. As long as you're OK with it, that's all that matters. Thanks for the update.
|
Not what I wanted either, Richie. It's too deep but it's not going to break the bank if it does my head in to the extent that I have to change the bezel. I'm also very lucky that RSC is only twenty minutes away on the bus.
Even when I re-locate back to the UK in 2018, there's an RSC halfway between my house and my office so no drama there either
Quote:
Originally Posted by Speed
Sounds like a great plan...and I must say you've got one of the best attitudes on TRF. Great enthusiasm in your posts - not to mention great Rolex / Pam models.
Enjoy your birthday Daytona. I still don't have one yet.
|
Thanks Bill
Quote:
Originally Posted by Camel
Paul, I'll try polishing it lightly with a Cape Cod cloth, just to smooth out the mark a bit - should make it less visible to the naked eye.
|
I wouldn't trust myself with one of those, Willem. I'll most likely make it worse. Once I decide enough is enough, I'll replace the bezel and be done
Quote:
Originally Posted by PatrickJ
Can't the bezel be replaced by RSC?
|
Yep, see above. S$400 all in
__________________
116520 Black, 116610 LVc, 116660 D-Blue, 116610 LNc, 116622 Blue, PAM359, PAM689, PAM737
"Why should you allow an AD to shake you down, just so you can buy a watch" - Grady Philpott
Card carrying member of TRF's Global Association of Retro-Grouch-Curmudgeons