Rolex Forums - Rolex Watch Forum - View Single Post

5 July 2006, 05:24 AM

I'm guessing that it should be possible to fit SEL endlinks on an A series 16610. Since I doubt they'd redesign the case mid-way through a production run, it makes sense it should fit. Talk to a good AD and see if it can be done. Rolex USA can be anal about changing something on a watch that it wasn't spec'ed with, but a good watchmaker should be able to answer the question for sure. But I'd guess because the endlinks are integrated into the upper part of the bracelet, I'm guessing you'd have to get a completely new bracelet, unless you can find either new old stock or something used (unlikely, given SEL has only been around for six years on the sub).

Good luck.

5 July 2006, 05:24 AM	#15
Atomic Guest Posts: n/a	I'm guessing that it should be possible to fit SEL endlinks on an A series 16610. Since I doubt they'd redesign the case mid-way through a production run, it makes sense it should fit. Talk to a good AD and see if it can be done. Rolex USA can be anal about changing something on a watch that it wasn't spec'ed with, but a good watchmaker should be able to answer the question for sure. But I'd guess because the endlinks are integrated into the upper part of the bracelet, I'm guessing you'd have to get a completely new bracelet, unless you can find either new old stock or something used (unlikely, given SEL has only been around for six years on the sub). Good luck.