Quote:
Originally Posted by saxo3
OMG, so you first dismantle the entire movement, clean everything in an ultrasound bath, then re-assemble with 'perfect' lubrications, then measure too low amplitudes and afterwards you must change one piece/component after the other (although you do not see any signs of wear) until you get acceptable amplitudes? Is that what you have to do?
Barely reach tolerances? What are the amplitude tolerances (H- and V- positions) after a service? I am curious to know these numbers (for my 32xx watches, two need a repair).
Bas, many thanks for all these information and explications, very interesting and much appreciated.
|
Correct, parts that did not show any sign of wear/deterioration at all that are replaced out of desperation to reach a minimum amplitude off 200 degrees after 24hrs.
A 24 hours test can be simulated by releasing a couple of ratchet wheel rotations.
This problem runs so much deeper than just migration of lubricants and a pivot that occasionally wear out prematurely.