Quote:
Originally Posted by Brainh18
Do I need to mask the lugs with tape with these?
|
No, you don't need tape as the springbar will never touch the case. Get a case cushion too, it's makes the job 100 times easier as you need have the endlink pressed firmly into the case cushion which means holding the watch head at a 45° angle as you compress the springbar.
Quote:
Originally Posted by nyfida
So your saying the 6825 is better than the 7825 ? I'm finally going to order one .
|
The FF forks (the finest available) don't fit Rolex unless you file them down, so no, I wouldn't say it's better
Quote:
Originally Posted by Blue_Lume
I have a hard time with this.
I bought a knock off tool for sub $50 from Asia - same thing exactly as the 6825 - but I'm horrible. I can't pinch the pin long enough to insert the bracelet in the head.
I bought he bullet and bought the 7825 for $170 - we'll see if it's any easier.
I hope it is, but probably not.
And I mean, mis handle the tweezer and the pin pops out and flies across the room into a shag carpet type of pain in the neck.
|
Get a case cushion. The small amount of give in the case cushion lets you position and hold the endlink correctly.