The Rolex Forums   The Rolex Watch

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX


Go Back   Rolex Forums - Rolex Watch Forum > General Topics > Open Discussion Forum

Reply
 
Thread Tools Display Modes
Old 22 May 2019, 12:52 AM   #1
emt1581
"TRF" Member
 
Join Date: May 2019
Location: PA
Posts: 65
Watch winder for new DJ?

I just bought my first Rolex last night. A LNIB 2018 DJ with blue dial. I plan on wearing it daily at the office Mon-Sat. So it should rarely sit for more than 24 hours and definitely less than 48hrs which would deplete the reserve. However, I want to buy a watch winder for safe storage of it and/or my current watch (Jean Marcel) that also needs to be wound. I usually put my current watch in my night stand on top of my Pilot Metro, Spyderco PM2, chapstick, and spare LCP mag. But I'm worried all that stuff will mar and scuff the DJ. So to keep it looking good I'd rather get a winder for both watches.


Does brand/model/features matter when looking at watch winders? Is it better for the watch to keep it wound or does it not matter if it goes dead and needs to be reset? Do these make any noise or can I keep it on my night stand?

Thanks!
emt1581 is offline   Reply With Quote
Old 22 May 2019, 01:18 AM   #2
Syed117
"TRF" Member
 
Syed117's Avatar
 
Join Date: Oct 2012
Real Name: Syed
Location: The Ether
Posts: 3,388
This has been discussed to death, but newcomers need help from time to time.

I personally don't like winders, but I do understand the convenience they offer.

A few things:

- Any decent quality winder will almost be silent so you can put it on your night stand.
- Do not use a cheap winder. They often lack proper shielding around the motors which can cause your watch to become magnetized. Not the end of the world, but annoying.
- A winder does not run non stop. It will run for a short amount of time and then turn off. A lot of people think a watch winder just keeping spinning watches forever. In reality they run for 5-15 minutes per hour depending on your turn per day settings and then stops.
- Prices vary wildly. You can get a two watch winder for anywhere from $50 to $5000
- Usually winders have a turn per day adjustment and also let you control whether the winding is unidirectional or bidirectional.
- Wolf winders seem to be a decent middle ground, but there are some decently priced ones on Amazon for around $150-$200.

Hope that helps. I'm sure others will chime in. Or they may not since a lot hate this topic.

Congrats on the watch btw!
__________________
Rolex Datejust 41 126334 | Omega Speedmaster Professional Hesalite | Cartier Santos Large | Tudor Black Bay 58
Syed117 is offline   Reply With Quote
Old 22 May 2019, 02:45 AM   #3
wesdaniel
2024 ROLEX DATEJUST41 Pledge Member
 
wesdaniel's Avatar
 
Join Date: Dec 2011
Real Name: Wes
Location: California
Watch: Varies
Posts: 1,324
Quote:
Originally Posted by Syed117 View Post
This has been discussed to death, but newcomers need help from time to time.

I personally don't like winders, but I do understand the convenience they offer.

A few things:

- Any decent quality winder will almost be silent so you can put it on your night stand.
- Do not use a cheap winder. They often lack proper shielding around the motors which can cause your watch to become magnetized. Not the end of the world, but annoying.
- A winder does not run non stop. It will run for a short amount of time and then turn off. A lot of people think a watch winder just keeping spinning watches forever. In reality they run for 5-15 minutes per hour depending on your turn per day settings and then stops.
- Prices vary wildly. You can get a two watch winder for anywhere from $50 to $5000
- Usually winders have a turn per day adjustment and also let you control whether the winding is unidirectional or bidirectional.
- Wolf winders seem to be a decent middle ground, but there are some decently priced ones on Amazon for around $150-$200.

Hope that helps. I'm sure others will chime in. Or they may not since a lot hate this topic.

Congrats on the watch btw!

What Syed said is pretty spot on.

I like winders - I keep all of my watches on them and have had no issues with magnetization, etc.

One of the best options that I've seen for a single winder is the Heiden Monaco watch winder on Amazon for $120. I have this and would easily take it over my Wolf winders. It has options for TPD as well as direction, it's silent and the pillow isn't massive.
wesdaniel is offline   Reply With Quote
Old 22 May 2019, 02:57 AM   #4
emt1581
"TRF" Member
 
Join Date: May 2019
Location: PA
Posts: 65
So it is healthy for the watch to use a winder or is it really just about not having to reset?

Thanks
emt1581 is offline   Reply With Quote
Old 22 May 2019, 03:06 AM   #5
TheVTCGuy
Banned
 
Join Date: Jul 2008
Real Name: Paul
Location: San Diego
Watch: 126619LB
Posts: 21,540
Quote:
Originally Posted by emt1581 View Post
So it is healthy for the watch to use a winder or is it really just about not having to reset?

Thanks
There has and always will be a million different and passionate opinions on this. Some swear it is better for the watch to keep running, others say let it run down. It has come close to causing a civil war here on TRF.

As for me? I use one. Annnnnddd.... I’m out.
TheVTCGuy is offline   Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

DavidSW Watches

Coronet

Takuya Watches

Bobs Watches

Asset Appeal

My Watch LLC

OCWatches


*Banners Of The Month*
This space is provided to horological resources.





Copyright ©2004-2024, The Rolex Forums. All Rights Reserved.

ROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEXROLEX

Rolex is a registered trademark of ROLEX USA. The Rolex Forums is not affiliated with ROLEX USA in any way.