Help with Identifying this AP Part

[jlycyvr]

so I ordered a conversion kit (bracelet to strap) for my 42mm ROO and this came with the kit. I suspect it was meant for attaching the plots to the case, but the metal bar actually does not fit all the way through the case and the screws dont seem to screw all the way in either. I was able to just use the original screws from the bracelet to attach the plots but it's left me wondering what this set is for? since i opened it i doubt they'd take it back..

[supernova]

It is for attaching the plots to the strap. You use the same bars and screws that were on the bracelet to case for attaching the plots to case.


Sent from my iPad using Tapatalk

[jlycyvr]

Originally Posted by supernova

It is for attaching the plots to the strap. You use the same bars and screws that were on the bracelet to case for attaching the plots to case.


Sent from my iPad using Tapatalk

hi thanks. but i actually have the parts that attaches the plots to the strap and it's one metal tube with thread on one end that attaches to a female screw cap at the other...unless there is another type of strap that takes one metal rod + 2 screws on either side? I have successfully done the 'conversion' to a rubber strap but don't see where these would go.

[jlycyvr]

i got all the parts in this pic...so not sure what the extra spare part shown in first post is for.

[jlycyvr]

I think I figured it out just for those who may be interested, it's for the 41mm RO case/plot.